Volg ons op:TwitterPinterestFacebookYouTubeLinkedInGoogle

taal

  • Inglese
  • Persiese
  • Franse
  • hindi
  • Japannese
  • Koreaanse
  • Italiaanse
  • Portugees
  • Russiese
  • Spaans
  • Thai
  • Turkse
Dongguan Taijishan Masjinerie Toerusting Co Ltd Banner
Tuis » produkte » Voerder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Grijper Feeder vir High Speed ​​Press Line

Grijper Feeder vir High Speed ​​Press Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Kontak Ons

  • Produk Beskrywing
  • Verpakking & Shipping
  • ons dienste
  • Vrae
  • ONDERSOEK
  • Verwante produk
Produk Beskrywing

Mechanical driver device for material feeder.Applied with swing wheel transfer cam.Material feed degree on 165°.With 15° stop area in the end of cam design.Pre-pressure middle of cam and accompany device.It will make sure zero gap and high-precision material feed.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
 
Tegniese data
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Left to right
Install Location Links
Deive axis round direction CW / CCW
Feeder Angle 165 Graad
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Graad
Press Plate Width 500 mm (Center max with 6 mm)
Lugdruk Min 0.44 mpa
Verpakking & Shipping

Shipping: Worldwide

ons dienste

Worldwide service

Vrae

Does this feeder sell seperately?

No, only come together with the press machine.

ONDERSOEK
Kontak Vorm
Jou Naam:*
Maatskappy Naam:
E-pos:*
Jou vraag:
Bevestig Kode:

Kontak Ons

Spyskaart
00000000