Prati nas:cvrkutPinterestfacebookyoutubeLinkedInGoogle

jezik

  • engleski
  • persijski
  • francuski
  • hindi
  • japanski
  • korejski
  • italijanski
  • portugalski
  • ruski
  • španski
  • thai
  • turski
Dongguan Taijishan Machinery Equipment Co Ltd Banner
POČETNA » Proizvodi » Feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder za brzi Press Line

Gripper Feeder za brzi Press Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Kontaktiraj nas

  • opis proizvoda
  • Pakiranje i dostava
  • naše usluge
  • FAQ
  • UPIT
  • Povezani proizvoda
opis proizvoda

Mehanički uređaj vozač za materijalne feeder.Applied sa prenosom swing točka cam.Material feed stepen na 165 ° .sa 15 ° stop područje na kraju cam design.Pre pritiskom sredinom cam i prate device.It ćemo se pobrinuti nula prazninu i visoko precizni materijal feed.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Tehnički podaci
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction S lijeva na desno
instalirati Lokacija lijevo
Deive axis round direction CW / CCW
Feeder Angle 165 Degree
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Degree
Press Plate Width 500 mm (Center max with 6 mm)
Zračni pritisak Min 0.44 mpa
Pakiranje i dostava

Dostava: Worldwide

naše usluge

širom svijeta usluga

FAQ

Da li to feeder prodati odvojeno?

No, only come together with the press machine.

Kontakt

Meni
G|translate Your license is inactive or expired, please subscribe again!