Dilynwch ni:twitterPinterestfacebookyoutubeLinkedIngoogle

iaith

  • Saesneg
  • persian
  • Ffrangeg
  • hindi
  • Siapan
  • Corea
  • Eidaleg
  • Portiwgaleg
  • Rwsieg
  • Sbaeneg
  • thai
  • turkish
Offer Dongguan Taijishan Machinery Co Ltd Baner
Cartref » cynhyrchion » Feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder am Cyflymder Llinell Wasg High

Gripper Feeder am Cyflymder Llinell Wasg High

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Cysylltwch â ni

  • Disgrifiad
  • Pecynnu a Llongau
  • ein gwasanaethau
  • Cwestiynau Cyffredin
  • YMCHWILIAD
  • Cynnyrch perthnasol
Disgrifiad

dyfais gyrrwr mecanyddol ar gyfer feeder.Applied perthnasol â throsglwyddo olwyn swing gradd bwydo cam.Material ar 165 15 ° Gyda ardal stop ° yn y diwedd y cam design.Pre pwysedd canol cam a gyd-fynd bydd device.It yn sicrhau sero bwlch a uchel-gywirdeb feed deunydd.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
cam Clutch a gyrru cam olwyn swing gan yr un cam device.Clutch eu cydosod â symud cam plât wasg, cam wasg sefydlog a cam tywys, Bydd yn gyrru'r clipwyr dan yr holl blatiau gwahanol yn symud i fyny ac yn gorffen down.So y datganiad a'r wasg angenrheidiol gweithgaredd yn ystod yn bwydo deunydd.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Data Technegol
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction O'r chwith i'r dde
Gosod Lleoliad Chwith
Deive axis round direction CW / CCW
Feeder Angle Gradd 165
Release Gap 0.5 mm
Press Gap 0.1 mm
Angle Rhyddhau Gradd 60
Lled Plât Wasg 500 mm (Center max with 6 mm)
Gwasgedd aer Min 0.44 ACM
Pecynnu a Llongau

Shipping: Worldwide

ein gwasanaethau

gwasanaeth Worldwide

Cwestiynau Cyffredin

A yw bwydo hwn yn gwerthu ar wahân?

Na, dim ond dod at ei gilydd gyda'r peiriant wasg.

Cyswllt

Dewislen
G|translate Your license is inactive or expired, please subscribe again!