Følg os:twitterpinterestfacebookyoutubeLinkedInGoogle

Sprog

  • Engelsk
  • persisk
  • fransk
  • Hindi
  • japansk
  • Korean
  • italiensk
  • portugisisk
  • russisk
  • spansk
  • Thai
  • tyrkisk
Dongguan Taijishan Machinery Equipment Co Ltd Banner
Hjem » Produkt » Feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder for High Speed ​​Press Linje

Gripper Feeder for High Speed ​​Press Linje

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Kontakt os

  • Produkt beskrivelse
  • Emballage og forsendelse
  • Vores ydelser
  • Ofte stillede spørgsmål
  • UNDERSØGELSE
  • Relateret produkt
Produkt beskrivelse

Mekanisk driver indretning til materielle feeder.Applied med swing hjulet transfer cam.Material foder graden 165 ° .Med 15 ° stop-område i enden af ​​cam design.Pre-tryk midt på cam og ledsager device.It vil sørge nul hul og høj præcision materiale feed.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Tekniske data
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Fra venstre mod højre
Installer Beliggenhed Venstre
Deive axis round direction CW / CCW
Feeder Angle 165 Degree
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Degree
Press Plate Width 500 mm (Center max with 6 mm)
Lufttryk Min 0.44 mpa
Emballage og forsendelse

Forsendelse: Worldwide

Vores ydelser

Worldwide tjeneste

Ofte stillede spørgsmål

Er denne feeder sælge seperat?

No, only come together with the press machine.

Kontakt os

menu
G|translate Your license is inactive or expired, please subscribe again!