Sekvu nin:pepiPinterestfacebookyoutubelinkedingoogle

lingvo

  • Angla
  • persa
  • franca
  • hindi
  • japanese
  • korean
  • itala
  • portugala
  • russian
  • hispana
  • taja
  • turkisoj
Dongguan Taijishan Maŝinaro Equipment Co. Ltd. Banner
hejmo » produktoj » Feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder por Alta Rapido Gazetaro Linio

Gripper Feeder por Alta Rapido Gazetaro Linio

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

kontaktu nin

  • Priskribo de la produkto
  • Prezentanta & Ekspedanta
  • niaj servoj
  • Oftaj Demandoj
  • ENKETO
  • rilataj produkto
Priskribo de la produkto

Mekanika ŝoforo aparato por materialoj feeder.Applied kun svingo rado transigo cam.Material manĝas grado sur 165 ° .With 15 ° halto areon en la fino de kamo design.Pre-premo mezo de kamo kaj akompani device.It estos certigi nulo breĉo kaj alta precizeco materialo fonto.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Teknikaj datumoj
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Maldekstre dekstren
instali Loko maldekstre
Deive axis round direction CW / CCW
Feeder Angle 165 Grado
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Grado
Press Plate Width 500 mm (Center max with 6 mm)
aero premo Min 0.44 mpa
Prezentanta & Ekspedanta

Ekspedanta: Tutmonda

niaj servoj

tutmonda servo

Oftaj Demandoj

Ĉu tio manĝanto vendi seperately?

No, only come together with the press machine.

Kontaktu nin

menuo
G|translate Your license is inactive or expired, please subscribe again!