Suivez-nous:twitterpinterestFacebookYoutubelinkedingoogle

Neuro Linguistique

  • English
  • persan
  • Français
  • Hindi
  • Japonais
  • Coréen
  • Italien
  • Portugais
  • Russe
  • Espagnol
  • Thai
  • turc
Dongguan Taijishan Machinery Equipment Co. Ltd. Bannière
Accueil » Produits » nourrisseur
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder pour High Speed ​​Press Line

Gripper Feeder pour High Speed ​​Press Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Contactez-nous

  • Description du produit
  • Emballage et expédition
  • Nos services
  • QFP
  • ENQUÊTE
  • De produits connexes
Description du produit

dispositif de commande mécanique pour feeder.Applied matériel avec transfert de roue swing degré d'alimentation cam.Material sur 165 ° .Avec 15 ° zone d'arrêt à la fin de la came centrale de la came design.Pre pression et accompagner device.It fera en sorte écart zéro et haute précision d'alimentation en matériau.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Données techniques
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction De gauche à droite
Emplacement d'installation À gauche
Deive axis round direction CW / CCW
Feeder Angle 165 Degré
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Degré
Press Plate Width 500 mm (Center max with 6 mm)
Pression de l'air Min 0.44 mpa
Emballage et expédition

Livraison: Worldwide

Nos services

Service mondial

QFP

Est-ce chargeur vendre séparément?

No, only come together with the press machine.

Contactez-Nous

Menu
G|translate Your license is inactive or expired, please subscribe again!