Lean Linn:twitterPinterestfacebookyoutubeLinkedIngoogle

teanga

  • english
  • Peirsis
  • Fraincis
  • hindi
  • Seapáinis
  • Cóiréis
  • italian
  • Portaingéilis
  • Rúisis
  • Spainnis
  • Téalainnis
  • Tuircis
Dongguan Taijishan Innealra Co Trealamh Ltd Banner
Baile » táirgí » Fothaire
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Fothaire do ardluais Líne Preas

Gripper Fothaire do ardluais Líne Preas

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Glaoigh orainn

  • Cur síos ar an Táirge
  • Pacáistiú & Loingseoireacht
  • ár seirbhísí
  • CC
  • INQUIRY
  • Táirge Gaolmhara
Cur síos ar an Táirge

Mechanical driver device for material feeder.Applied with swing wheel transfer cam.Material feed degree on 165°.With 15° stop area in the end of cam design.Pre-pressure middle of cam and accompany device.It will make sure zero gap and high-precision material feed.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
 
Sonraí Teicniúil
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Left to right
Install Location Clé
Deive axis round direction CW / CCW
Feeder Angle Céim 165
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle Céim 60
Press Plate Width 500 mm (Center max with 6 mm)
Brú Aeir Min 0.44 mpa
Pacáistiú & Loingseoireacht

Shipping: Worldwide

ár seirbhísí

Worldwide service

CC

Does this feeder sell seperately?

No, only come together with the press machine.

INQUIRY
Déan teagmháil le Foirm
Do Ainm:*
Ainm na Cuideachta:
R-phost:*
Do Fiosrúcháin:
Dearbhaigh Cód:

Glaoigh orainn

roghchlár