Segwi Us:twitterPinterestFacebookYouTubelinkedingoogle

lingwa

  • Ingliż
  • Persjan
  • Franċiż
  • Ħindi
  • Ġappuniż
  • korean
  • Taljan
  • Portugiż
  • Russu
  • Spanjol
  • Tajlandiż
  • Tork
Dongguan Taijishan Makkinarju Equipment Co Ltd Banner
home » prodotti » Feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder għall Veloċità Għolja istampa Linja

Gripper Feeder għall Veloċità Għolja istampa Linja

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Ikkuntatjana

  • Deskrizzjoni tal-prodott
  • Ippakkettjar & Shipping
  • Is-servizzi tagħna
  • FAQ
  • INKJESTA
  • Related Prodott
Deskrizzjoni tal-prodott

apparat sewwieq mekkaniku għall feeder.Applied materjal ma trasferiment rota jitbandal grad għalf cam.Material fuq 165 ° Mal 15 ° żona waqfa fl-aħħar ta cam nofs design.Pre-pressjoni ta 'cam u jakkumpanjaw device.It se tiżgura vojt żero u ta 'preċiżjoni għolja materjal ta' għalf.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Data teknika
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Xellug għal-lemin
jinstallaw Post Xellug
Deive axis round direction CW / CCW
Feeder Angle 165 Grad
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Grad
Press Plate Width 500 mm (Center max with 6 mm)
Pressjoni Ajru Min 0.44 mpa
Ippakkettjar & Shipping

Trasport bil-baħar: Madwar id-dinja

Is-servizzi tagħna

servizz Worldwide

FAQ

Does this alimentatriċi jbiegħu separatament?

No, only come together with the press machine.

Ikkuntatjana

menu
G|translate Your license is inactive or expired, please subscribe again!