Mulimuli i Tatou:TwitterpinterestFacebookYouTubelinkedingoogle

gagana

  • le gagana Peretania
  • Peresia
  • Farani
  • Hindi
  • Iapani
  • Korea
  • Italia
  • Potukale
  • Rusia
  • Sipaniolo
  • Tai
  • Take
Dongguan Taijishan Masini Meafaigaluega Co. Ltd. Banner
aiga » Products » e fafaga
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper e fafaga mo Ese Speed ​​Press Line

Gripper e fafaga mo Ese Speed ​​Press Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Faafesootai matou

  • Faamatalaga oloa
  • Afifiina & Vaa
  • tatou auaunaga
  • FAQ
  • fesili
  • Oloa Fesootai
Faamatalaga oloa

masini avetaavale masini mo mea feeder.Applied ma taupega uili tikeri feed cam.Material faaliliuina i 165 ° .With 15 ° tu eria i le faaiuga o Cam ogatotonu design.Pre-uunaiga o Cam ma faatasi ma le a faia device.It mautinoa va o ma feed mea tonu-maualuga.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
faamatalaga Technical
Feeder Length mm 0-80
Feeder Width mm 8-80
Max material Thickness 2.0 mm
Material Direction Tauagavale i le taumatau
faatuina Nofoaga tauagavale
Deive axis round direction CW / CCW
Feeder Angle 165 tikeri
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 tikeri
Press Plate Width 500 mm (Center max with 6 mm)
Faatosinaga Air Min 0.44 mpa
Afifiina & Vaa

Vaa: i le Lalolagi Atoa

tatou auaunaga

auaunaga i le Lalolagi Atoa

FAQ

E faatau atu lenei e fafaga seperately?

No, only come together with the press machine.

Faafesootai matou

menu
G|translate Your license is inactive or expired, please subscribe again!