Tuturkeun Kami:twitterPinterestfacebookyoutubeLinkedIngoogle

basa

  • Inggris
  • Pérsia
  • Perancis
  • Hindi
  • Jepang
  • Koréa
  • Italia
  • Portugis
  • Rusia
  • Spanyol
  • Thailand
  • Turki
Dongguan Taijishan mesin Equipment Co. Ltd. Banner
imah » produk » feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper feeder pikeun Speed ​​High Pencét Line

Gripper feeder pikeun Speed ​​High Pencét Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Taros Kami

  • Panjelasan Produk
  • Bungkusan & pengiriman barang
  • jasa kami
  • FAQ
  • panalungtikan
  • Produk Biomédis
Panjelasan Produk

alat supir mékanis pikeun feeder.Applied bahan kalawan mindahkeun ayun kabayang gelar feed cam.Material on 165 ° .With 15 ° aréa eureun di tungtung Cam design.Pre-tekanan tengah Cam tur marengan device.It bakal mastikeun enol gap na luhur-precision feed bahan.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
data téknis
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Kenca ka katuhu
install lokasi ditinggalkeun
Deive axis round direction CW / CCW
Feeder Angle 165 Gelar
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Gelar
Press Plate Width 500 mm (Center max with 6 mm)
tekenan hawa Min 0.44 mpa
Bungkusan & pengiriman barang

Pengiriman barang: Di sakuliah dunya

jasa kami

jasa di sakuliah dunya

FAQ

Teu feeder ieu ngajual seperately?

No, only come together with the press machine.

Taros Kami

menu
G|translate Your license is inactive or expired, please subscribe again!