Sundin sa Amin:kabapinterestfacebookyoutubeLinkedIngoogle

wika

  • Ingles
  • Persyano
  • Pranses
  • Hindi
  • Hapon
  • Koreano
  • Italyano
  • Portuges
  • Ruso
  • Espanyol
  • Thai
  • Turko
Dongguan Taijishan Makinarya Kagamitan Co. Ltd. Banner
Home » Mga Produkto » Feeder
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper Feeder para sa High Speed ​​Press Line

Gripper Feeder para sa High Speed ​​Press Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Makipag-ugnayan sa amin

  • Paglalarawan ng produkto
  • Packaging & Shipping
  • Ang aming serbisyo
  • FAQ
  • INQUIRY
  • Mga kaugnay na produkto
Paglalarawan ng produkto

Mechanical driver ng aparato para sa materyal na feeder.Applied may swing wheel transfer cam.Material feed degree sa 165 ° .Gamit 15 ° stop na lugar sa dulo ng cam design.Pre-pressure gitna ng cam at samahan ang device.It Titiyakin ng zero gap at high-precision materyal feed.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
Teknikal na data
Feeder Length 0 80-mm
Feeder Width 8 80-mm
Max material Thickness 2.0 mm
Material Direction Kaliwa pakanan
I-install Lokasyon Kaliwa
Deive axis round direction CW / CCW
Feeder Angle 165 Degree
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 Degree
Press Plate Width 500 mm (Center max with 6 mm)
Air Pressure Min 0.44 mpa
Packaging & Shipping

Pagpapadala: Sa buong mundo

Ang aming serbisyo

Pandaigdigang service

FAQ

Ba ito feeder ibenta seperately?

No, only come together with the press machine.

Makipag-ugnay sa

menu
G|translate Your license is inactive or expired, please subscribe again!