Tẹle wa:twitterpinterestfacebookyoutubelinkedingoogle

Language

  • Èdè Gẹẹsì
  • Persian
  • French
  • Hindi
  • Japanese
  • Korean
  • Italian
  • Portuguese
  • Russian
  • Spanish
  • Thai
  • Turkish
Dongguan Taijishan Machinery Equipment Co. Ltd. Asia
Home » awọn ọja » atokan
  • /img/gripper_feeder_for_high_speed_press_line.jpg
  • Gripper atokan fun gaju Šiše Press Line

Gripper atokan fun gaju Šiše Press Line

Mechanical driver device for material feeder, Applied with swing sheel transfer cam. Material feed degree on 165 . With degree 15 stop area in the end of cam design. Pre-pressure between middle of cam and accompany device. It will make sure zero gap and high-precision material feed.

Pe wa

  • Ọja Apejuwe
  • Apoti & Ako
  • iṣẹ wa
  • FAQ
  • lorun
  • ti o ni ibatan ọja
Ọja Apejuwe

Darí iwakọ ẹrọ fun awọn ohun elo ti feeder.Applied pẹlu golifu kẹkẹ gbigbe cam.Material kikọ sii ìyí on 165 ° .With 15 ° Duro agbegbe ni opin ti Kame.awo-ori design.Pre-titẹ arin ti Kame.awo-ori ati ki o rin device.It yoo rii daju odo aafo ati ga-konge ohun elo ti kikọ sii.

Surface contact design with material press area.It will decrease the pressure on the material surface.No scratch issues happen even if soft material.
Clutch cam and swing wheel cam drive by the same device.Clutch cam be assembled with moving press plate cam,Fixed press cam and guided cam,It will drive the clippers under all different plates moving up and down.So finished the necessary release and press activity during in material feeder.
Material feed length will be adjusted by the face side hand-roll. During the operating also you can change the material feed length.Material tenth will be showed in digital display with 1% millimeters precision.
Material thickness change will be adjusted by the left side bolt,And will be confirmed with the face side dial device.
Very easy to clean the material guider.Clippers because all drive devices be designed in under material feeder surface.
jijẹmọ data
Feeder Length 0-80 mm
Feeder Width 8-80 mm
Max material Thickness 2.0 mm
Material Direction Osi si ọtun
fi sori ẹrọ Location osi
Deive axis round direction CW / CCW
Feeder Angle 165 ìyí
Release Gap 0.5 mm
Press Gap 0.1 mm
Release Angle 60 ìyí
Press Plate Width 500 mm (Center max with 6 mm)
air Ipa Min 0.44 mpa
Apoti & Ako

Sowo: Worldwide

iṣẹ wa

ni agbaye iṣẹ

FAQ

Ko ni yi atokan ta seperately?

No, only come together with the press machine.

Pe wa

akojọ
G|translate Your license is inactive or expired, please subscribe again!